Marks Across Panel Face

 

    

Chatter

Causes Corrections
Imbalance to contact roll, idler, worn bearings, bearing journals, fluttery, loose or damaged belt drive components, feed roll irregularities 
  • Dynamically balance contact roll and idler 

  • Redress roll 

  • Align and mount the abrasive belt drives 

Too rapid or shaky abrasive belt tracking oscillation 
  • Slow down oscillation to a non-shocking movement 

Loose moving parts of machine such as jacks, tie bars, etc. 
  • Tighten all loose areas  

  • Make certain that movement of vital parts is not impaired

Flimsy, curled or fluttery abrasive belt edges 
  • Replace abrasive belt  

Too high or too low abrasive belt tension will cause belts to flutter and create machine vibration 
  • Lower or increase tension to a point where belts run smoothly 

Mastercard Visa

We accept Matercard, Visa and Interac

TISI © 2000 - 2007 HomeCustomer ServiceWhy TISI? Troubleshooting GuideTerms & Conditions Site Map Staff Login

Graphic Design by RTB Wizards

Site Created by Shannon Devantier

Monday, February 12, 2007 07:29:40 PM -0700

footer image footer image