Marks Across Panel Face

 
Home • About Us • Products • FAQs • Contact Us • News & Events • Setup An Account  • Links

    

Feed Marks
Causes Corrections
Loose cones or belts on motor drive, loose chain drive coupling 

  • Repair or replace drive 

  • Make snug 

  • Should not gallop or vibrate

Pinch rolls, guide bars, pressure shoes incorrectly set; too much pressure or guide bars etc.; too low or too high in relation to stock removal setting 

  • Reset according to manufacturer's machine set-up instructions 

Build-up on feed rolls, idler rolls or glazed feed belt 

  • Clean-up and make sure all is straight/flat 

  • Correct and/or prevent dust build-up 

  • Dress feed belt to remove hard surface glaze

Mastercard Visa

We accept Matercard, Visa and Interac
TISI © 2000 - 2007 Home • Customer Service • Why TISI? • Troubleshooting Guide • Terms & Conditions • Site Map • Staff Login

Graphic Design by RTB Wizards

Site Created by Shannon Devantier

Monday, February 12, 2007 07:29:40 PM -0700
footer image footer image